26.4.3 Build Cross Host Tools

back: canadian cross concepts
forward: build and host options
fastback: build and host options
up: building with a cross compiler
fastforward: installing gnu autotools
top: autoconf, automake, and libtool
contents: table of contents
index: index
about: about this document

In order to configure a program for a Canadian Cross build, you must first build and install the set of cross tools you will use to build the program. These tools will be build cross host tools. That is, they will run on the build system, and will produce code that runs on the host system. It is easy to confuse the meaning of build and host here. Always remember that the build system is where you are doing the build, and the host system is where the resulting program will run. Therefore, you need a build cross host compiler.

In general, you must have a complete cross environment in order to do the build. This normally means a cross compiler, cross assembler, and so forth, as well as libraries and header files for the host system. Setting up a complete cross environment can be complex, and is beyond the scope of this book. You may be able to get more information from the `crossgcc' mailing list and FAQ; see http://www.objsw.com/CrossGCC/.

This document was generated by Gary V. Vaughan on May, 24 2001 using texi2html

GNU Autoconf, Automake and Libtool
GNU Autoconf, Automake, and Libtool
ISBN: 1578701902
EAN: 2147483647
Year: 2002
Pages: 290

flylib.com © 2008-2017.
If you may any questions please contact us: flylib@qtcs.net