5.2 Replication Implementation Overview

MySQL replication is based on the master server keeping track of all changes to your databases (updates, deletes, and so on) in the binary logs. Therefore, to use replication, you must enable binary logging on the master server. See Section 4.8.4, "The Binary Log."

Each slave server receives from the master the saved updates that the master has recorded in its binary log, so that the slave can execute the same updates on its copy of the data.

It is very important to realize that the binary log is simply a record starting from the fixed point in time at which you enable binary logging. Any slaves that you set up will need copies of the databases on your master as they existed at the moment you enabled binary logging on the master. If you start your slaves with databases that are not the same as what was on the master when the binary log was started, your slaves may fail.

One way to copy the master's data to the slave is to use the LOAD DATA FROM MASTER statement. Be aware that LOAD DATA FROM MASTER is available only as of MySQL 4.0.0 and currently works only if all the tables on the master are MyISAM type. Also, this statement acquires a global read lock, so no updates on the master are possible while the tables are being transferred to the slave. When we implement lock-free hot table backup (in MySQL 5.0), this global read lock will no longer be necessary.

Due to these limitations, we recommend that at this point you use LOAD DATA FROM MASTER only if the dataset on the master is relatively small, or if a prolonged read lock on the master is acceptable. While the actual speed of LOAD DATA FROM MASTER may vary from system to system, a good rule of thumb for how long it will take is 1 second per 1MB of data. That is only a rough estimate, but you should get close to it if both master and slave are equivalent to 700MHz Pentium performance and are connected through a 100MBit/s network.

After the slave has been set up with a copy of the master's data, it will simply connect to the master and wait for updates to process. If the master goes away or the slave loses connectivity with your master, it will keep trying to connect periodically until it is able to reconnect and resume listening for updates. The retry interval is controlled by the --master-connect-retry option. The default is 60 seconds.

Each slave keeps track of where it left off. The master server has no knowledge of how many slaves there are or which ones are up to date at any given time.