QA

     

Q&A

As mentioned in the introduction, "All About the CCNP, CCDP, and CCIP Certifications," you have two choices for review questions. The questions that follow next give you a bigger challenge than the exam itself by using an open -ended question format. By reviewing now with this more difficult question format, you can exercise your memory better and prove your conceptual and factual knowledge of this chapter. The answers to these questions are found in Appendix A.

For more practice with examlike question formats, including questions using a router simulator and multichoice questions, use the exam engine on the CD-ROM.

1:	What command is used to configure the Integrated IS-IS router process?
2:	What is the default routing level on a Cisco router?
3:	What command is used to configure Integrated IS-IS routing on the interface?
4:	How is the NET address configured on the router?
5:	What command is used to show the state of adjacencies on the router?
6:	What command identifies the designated intermediate system router for your LAN?
7:	Explain briefly what show isis database reveals.
8:	What command reveals the trigger for the last SPF calculation on the router?
9:	For Frame Relay, when would you configure the map command with the broadcast parameter?
10:	Which command is used to display all update packets that are both received and sent by a router?
11:	State two reasons why a router may not be able to find a neighbor.
12:	Which command shows the LSPs in detail?
13:	How would you ensure that an adjacency has been established?
14:	What are the steps required for a basic configuration in IS-IS?
15:	Give the commands required to summarize the networks 10.10.0.0 through to 10.10.255.0 into another area of IS-IS.
16:	Which command verifies the circuit type and the metric?
17:	Which network topology defaults in the Broadcast mode?
18:	For which WAN topology is a point-to-point configuration recommended?
19:	When is it necessary to map CLNS to the DLCI?
20:	In the show clns interface command, it is possible to identify the DIS on a multiaccess link. Which field in the output screen of this command would show the DIS for the segment?