Test Your Knowledge

   

---

1:	Which command is used to list network drivers configured into the kernel? lanscan ioscan lanadmin lsdev
2:	For what purpose is the ifconfig command used? assigning the IP address to a network interface displaying the configured IP address of a network interface assigning the IP address to a virtual network interface all of the above
3:	The following statements are related to the assignment of IP addresses to network interfaces. Which of these is true? Multiple netmask values can be assigned with a single IP address. More than one physical adapter can have IP addresses that fall into the same network address. A broadcast address is used to send a message to all computers on the Internet. The ifconfig command can be used to set the MAC address of a network interface.
4:	For what purpose is the /etc/rc.config.d/ netconf file used? It is a script used to configure network adapters. It is a text file that contains configuration information for network interfaces. It contains hardware addresses assigned to network interfaces. It contains dynamic routing information.
5:	Which command is used to display a routing table? route netstat ifconfig all of the above
6:	When creating a default route, you see a network unreachable message. What may be the cause? The router is down. The router address does not fall into any network address assigned to the host. The cable to the router is faulty. An end terminator for a coaxial cable is missing.
7:	Which command is used for listing installed network adapters? lanscan ioscan both of the above none of the above

---

   

Top