Question 1 | Which of the following is a process by which a router immediately informs its neighbors about routing updates? -
A. Split horizon -
B. Poison reverse -
C. Hold-down timers -
D. Triggered updates |
A1: | Answer: D . Routers use triggered updates to inform neighbors about routing updates immediately, so they don't have to wait for regular timed updates. |
Question 2 | Which command enables you to see the routing table? |
A2: | Answer: B. Using the show ip route command enables you to see the routing table. |
Question 3 | RIP2, following RIP1, is able to support which of the following? [Choose the three best answers.] |
A3: | Answer: B, C, D . RIP2 is able to support Classless Interdomain Routing (CIDR), route summarization, and variable-length subnet masks (VLSMs). |
Question 4 | Suppose you are running OSPF in your core backbone routers and running RIP on the edge networks. You notice that a few of the networks are not receiving IP packets. After logging in to the router, what command should you use to see who is running OSPF? |
A4: | Answer: B . Using the show ip ospf neighbors command enables you to see who is running OSPF, and will list all routing information on all of the enabled OSPF interfaces. |
Question 5 | Which routing methods might cause a routing loop? [Choose the two best answers.] -
A. Split horizon has been disabled on an interface -
B. IP multicast routing is not enabled -
C. Hold-down timers are not consistent across the network -
D. Invalid IP addresses exist on the network |
A5: | Answer: A, C . If split horizon has been disabled on the interface or the hold-down timers are not consistent across the network, a routing loop may be caused. |
Question 6 | Of the following, which protocol is considered a hybrid (meaning it uses both distance-vector and link-state routing algorithm)? -
A. RIP -
B. EIGRP -
C. IGRP -
D. IS-IS |
A6: | Answer: B . EIGRP is an enhanced version of IGRP. EIGRP supports both routing algorithms and provides less opportunity for routing failures. EIGRP also converges very fast because it only calculates when a change in the network directly affects the routing table. |
Question 7 | Classless subnet masks can be used by which of the following routing protocols? [Choose the two best answers.] -
A. IGRP -
B. EIGRP -
C. OSPF -
D. RIP v1 |
A7: | Answer: B, C . EIGRP and OSPF support variable-length subnet masks (VLSMs) and classless address spaces. Answers A and D are incorrect because neither RIP v1 nor IGRP supports VLSM or classless addressing. |
Question 8 | Pick three valid IP show commands from the following: -
A. show ip route -
B. show ip interface -
C. show ip protocols -
D. show ip-route -
E. show protocols -
F. show ip-interface |
A8: | Answer: A, B, C . The other commands are invalid. |
Question 9 | Which commands would you use to see the contents of a route map? [Choose the two best answers.] -
A. show running-config -
B. show ip route-map -
C. show route-map -
D. show ip interface |
A9: | Answer: A, C . Using the show running-config and show route-map commands enables you to see the contents of a route map. |
Question 10 | Which of the following protocols is considered an exterior routing protocol? -
A. RIP -
B. EIGRP -
C. BGP -
D. OSPF |
A10: | Answer: C . BGP is considered an exterior routing protocol that connects autonomous systems together. The latest version is BGP v4 and is mainly used by the ISP's. |