Configure the IP routing as in Figure 3-13 as directed.
Figure 3-13. IP IGP Diagram
Section 2.1: EIGRP (7 Points)
Configure EIGRP AS1 as shown in Figure 3-13. Initial loopback interfaces should be advertised within EIGRP for every router running EIGRP.
Authenticate routing updates.
Allow R3 to only receive routing updates from R2 even if a further EIGRP router is added to VLAN1.
Section 2.2: OSPF (5 Points)
Configure OSPF as shown in Figure 3-13 with the process on each router as 1. Ensure that all OSPF routers have their loopback interfaces advertised in the same area as that of the Ethernet interface.
Do not use the ip ospf network command over the Frame Relay network.
Ensure that no host routes are propagated throughout the network.
Section 2.3: Redistribution (4 Points)
Redistribute OSPF into EIGRP on R2; do not perform mutual redistribution and only allow OPSF routes with a mask greater than 255.255.0.0 into EIGRP.