Configure a QoS policy on R2 for traffic flowing from VLAN1 toward the rest of your network. Traffic found to have an IP precedence of 7, 5, and 1 should be limited to a maximum of 2 Mbps. Traffic above this figure with the stated precedence should be discarded. Use only one ACL to accomplish this requirement. Assume normal and excess burst sizes to both be 40000.
A future FXS module will be installed into R6 and VoIP traffic will flow between R1 and R6. Configure RSVP on R1 so that the RSVP setup must be complete before the destination phone rings. Each RSVP flow should be set to 100 kbps and allow for a maximum of 2 flows; allow a maximum of 15 seconds for this setup. You should also allow for 64 discard messages and 64 dynamic queues in your QoS configuration. You are not required to perform any configuration on R6 but can assume that the phone number on R6 will be 01962 when configuring the dial plan on R1.
