Answers to the review questions can be found in Appendix A, "Answers to Review Questions."
1:
What are the first three steps to check if the user never receives an Authenticating User prompt during the initial dialer connection attempt in the VPN software client?
2:
What is the CVPND event class and what is its purpose?
3:
Name the main severity categories in the Cisco VPN concentrator?
4:
In a 3002 HW VPN client, the user is authenticated but cannot pass any data. What are two possible reasons?
5:
Which severity level events are displayed by default on the VPN HW 3002 client?
6:
How do you proceed if a NAT/PAT configuration already exists in the router and you are about to configure an Easy VPN client?
7:
What is the command for the Easy VPN client to reset the VPN connection?
8:
What is the command for Easy VPN to check the status of the Cisco Easy VPN client profile?
9:
To verify the applied policy in Cisco Easy VPN, what command do you use?
10:
In the PIX-based VPN client, how do you verify if the VPN client is active?
11:
In the PIX-based VPN client, how do you check that the VPN tunnel has been established?
12:
What are two debug commands to debug the PIX-based VPN establishment of IPSec and ISAKMP?
13:
What parameters define the PPPoE session uniquely?
14:
Name the modulation techniques for the DOCSIS 2.0 standard.
15:
If the TCP protocol is notified for packet loss, how does it react?
