Answers to the review questions can be found in Appendix A, "Answers to Review Questions."
1:
What is dynamic mapping?
2:
For Router-frame, map the IP address 10.0.0.1 to DLCI = 100, using the IETF encapsulation.
3:
Can you use IP unnumbered with Frame Relay?
4:
Can you ping your own interface address? Can you ping one spoke router from another?
5:
What happens to deleted subinterfaces?
6:
In point-to-point configurations that are running EIGRP, type the command for Router-frame that prevents all routing updates for interface Serial3/0:0.64?
7:
Configure the Frame Relay broadcast queue for Router-framesubinterface S3/0:0.71 with queue size 100, byte rate 1200, and packet rate 120.
8:
Can you configure the Cisco router as a DCE?
9:
Under the interface Serial3/0:0.200, what is the backup delay command with enable delay = 5 seconds and disable delay = 10 seconds?
10:
For Router-frame and interface Serial1, what is the command for TCP header compression, which is active only for the destinations that are sending compressed headers?
11:
For Router-frame and interface Serial4/2:0.200, define that FRF9 payload compression will be performed on CSA 3.
12:
Enable the multicast routing in Router-frame.
13:
In Router-frame, for interface Serial4/2:0.100, define the upper limit of the rate for traffic shaping to 128000.
14:
What Frame Relay timer defines the Cisco autosense feature? How do you configure it?