You will also select the mouth with the Lasso tool:
Choose the Lasso tool. Because the feather radius was set for the Lasso tool in the previous step, it doesn t need to be reset. Encircle one of the mouths as close to its edge as possible.
Choose the Move tool. In the Options bar, select the Show Bounding Box check box. Place the cursor inside the bounding box. Drag the mouth and place it on the egg. Press the Shift key while dragging to constrain the proportions .
To size the mouth, place your cursor on any one of the bounding box handles, and drag inward to decrease or outward to increase the size , as in Figure H1.11.
Figure H1.11: Sizing the mouth
Press the /Ctrl key to independently move the corner points of the bounding box to distort the mouth.
To rotate the mouth, place the cursor on the outside corner of the box until the rotate icon appears and then drag.
If you would like to see the mouth without the marquee to get a better idea of how it looks, choose View ’ Show ’ Selection Edges or press /Ctrl-H. The selection remains active, but the marquee becomes concealed. To display the marquee again, choose the same menu item or key command.
In the Options bar, click the check mark to commit the transformation or the Cancel icon to cancel it .
Deselect and save the document.