20-62 show ip ospf process-id virtual-links

< Free Open Study >

Syntax Description:

process-id ” The OSPF process ID. The range of values is 1 to 4,294,967,295.

Purpose: To display the status and information regarding any virtual links that have been configured on the router. An OSPF process ID can be used if more than one OSPF process is active using the form show ip ospf process-id virtual-links. The output of this command can be filtered, using regular expressions, by one of the following forms:

  show ip ospf virtual-links   begin   regular-expression   show ip ospf virtual-links   exclude   regular-expression   show ip ospf virtual-links   include   regular-expression

Initial Cisco IOS Software Release: 10.0

Example: Displaying the Status of All Virtual Links Configured on the Local Router

The following is a representative output from the show ip ospf virtual-links EXEC command.

 r1#  show ip ospf virtual-links  Virtual Link OSPF_VL0 to router 2.2.2.2 is up   Run as demand circuit   DoNotAge LSA allowed.   Transit area 1, via interface Serial0/0, Cost of using 64   Transmit Delay is 1 sec, State POINT_TO_POINT,   Timer intervals configured, Hello 10, Dead 40, Wait 40, Retransmit 5     Hello due in 00:00:01     Adjacency State FULL (Hello suppressed)

< Free Open Study >