Start a new drawing from scratch. Set the grid to ¼" and create the image in Figure 8.6.1a. Save the drawing as MyArrows in the C:\Steps\Lesson08 folder.
Figure 8.6.1a:
Set up a new drawing with the following parameters:
2.1 | Lower left limits: 0,0 |
2.2 | Upper right limits: 16,16 |
2.3 | Grid: 1 |
2.4 | Snap: as needed |
2.5 | Textsize: 5/8 |
2.6 | Text style: Arial font, Bold and Italicized |
2.7 | Layers: as created in Lesson 7 Exercise #3 |
2.8 | Create the backgammon board shown in Figure 8.6.2a. Save the drawing as MyBoard in the C:\Steps\Lesson08 folder. |
The drawing shown in Figure 8.6.3a is a piping isometric of some pump discharge pipe.
Figure 8.6.3a: Piping Iso
3.1 | Set up the drawing as follows :
| ||||||||||||||||||||||||||||||||||||||||||||||||||||
3.2 | Details:
| ||||||||||||||||||||||||||||||||||||||||||||||||||||
3.3 | Create the drawing. Save the drawing as MyPipingIso in the C:\Steps\Lesson08 folder. |
Use the same settings as in Exercise 3, but make the polyline width 1/32 for the pipe and for the valves in the drawings in Figures 8.6.4a and 8.6.4b. The grid is ¼". Save the drawings as MyIso1 and MyIso2 in the C:\Steps\Lesson08 folder.
Figure 8.6.4a:
Figure 8.6.4b:
Figures 8.6.5a is one of the cards from my computer.
Figure 8.6.5a:
5.1 | Draw it using the following setup:
| ||||||||||||||||||||||||||||||||||||||
5.2 | Details:
| ||||||||||||||||||||||||||||||||||||||
5.3 | Save the drawing as MyCard in the C:\Steps\Lesson08 folder. |
Create the electrical schematic shown in Figure 8.6.6a.
Figure 8.6.6a: Electrical Schematic
The grid is 0.5
Large polylines have a ¼" width
Small polylines have a 1/16" width