1. | What drive select jumper settings are available on a typical IDE hard drive? |
|
2. | Which drive is usually installed as the master drive on the primary IDE interface? |
|
3. | For a new hard drive, where are you likely to find the information needed to set up the CMOS? |
|
4. | If the CMOS is set to auto-detect hard drives and the hard drive is detected with cylinders, heads, or sectors that are different from those listed on the hard drive label, what should you do? |
|
Answers
1. | Drive select jumpers let you choose between master, slave, or cable select. |
2. | The bootable hard drive is usually installed as the master hard drive on the primary IDE interface. |
3. | The hard-drive information for CMOS setup is usually found on the hard drive’s label. |
4. | Manually set the hard-drive values in CMOS. |