Configure R8 so that when R6 FastEthernet4/0 (10.60.60.1) connects to virtual IP address 10.80.80.12, that traffic is actually sent to R2 Serial 0/0 (10.90.90.1). When R1 receives the traffic from R6, it should see the source address of 10.8.8.2 for this operation. Do not perform any policy routing in your solution.
Manipulate the EIGRP authentication to change the keys as follows: The first key should remain active from the time you started this lab today and remain active for two days after that; the second key should then become active permanently. Allow an overlap of 20 minutes but ensure that all EIGRP routers have a common synchronized time source provided by one of your routers to ensure reliable operation.
Configure R7 not to send each character of a Telnet session as a separate CPU interrupt to your network devices. Characters should be buffered until an acknowledgment is received to reduce CPU interrupts and improve on bandwidth limitations.
Prevent the configuration prompt from being displayed on R5 when in config mode.
