Start a new drawing. Set it up as follows :
1.1 | Units: architectural |
1.2 | Lower left limits: 0,0 |
1.3 | Upper right limits: 17,11 |
1.4 | Grid: 1 |
1.5 | Snap: ½ |
1.6 | Save this as a template file called MyGrid1.dwt to the C:\Steps\Lesson03 folder. |
Start a new drawing. Set it up as follows:
2.1 | Units: decimal |
2.2 | Lower left limits: 0,0 |
2.3 | Upper right limits: 11,8.5 |
2.4 | Grid: ½ |
2.5 | Snap: ¼ |
2.6 | Snap style: isometric. |
2.7 | Save this as a template file called MyIsoGrid1.dwt to the C:\Steps\Lesson03 folder. |
Start a new drawing. Set it up as follows:
3.1 | Units: architectural |
3.2 | Lower left limits: 0,0 |
3.3 | Upper right limits: 17,11 |
3.4 | Grid: ½ |
3.5 | Snap: ¼ |
3.6 | Snap style: isometric |
3.7 | Save this as a template file called MyIsoGrid2.dwt to the C:\Steps\Lesson03 folder. |
For each of the drawings in Figures 3.9.4.1a through 3.9.4.6a, start a new drawing using the MyIsoGrid2 template file created in Exercise 3. (If this file is not available, use the IsoGrid2 template in the same folder.) Draw the figures and save them as their figure name /number in the C:\Steps\Lesson03 folder.
Figure 3.9.4.1a:
Figure 3.9.4.2a:
Figure 3.9.4.3a:
Figure 3.9.4.4a:
Figure 3.9.4.5a:
Figure 3.9.4.6a:
Open the raygun drawing in the C:\Steps\Lesson03 folder. Using what you learned about OSNAPS, complete the ray gun in Figure 3.9.5a.
Figure 3.9.5a:
Create the fireplace framing shown in Figures 3.9.6a and 3.9.7a. Use 2 x 4 framing and set your drawing limits to 8',8'.
Figure 3.9.6a:
Figure 3.9.7a: