Wireless Access Points


Unlike cabled networks, wireless networks don't need a hub or switch. If all you want to do is network a group of wireless computers, you just purchase a wireless adapter for each computer, put them all within 300 feet of each other, and voilà!-instant network.

What if you already have an existing cabled network? For example, you may work at an office with 15 computers all cabled up nicely, and you just want to add a couple of wireless notebook computers to the network. Or, suppose that you have two computers in your den connected to each other with network cable but you want to link up a computer in your bedroom without pulling cable through the attic.

That's where a wireless access point, or WAP, comes in. A WAP performs two functions:

  • The WAP acts as a central connection point for all your computers that have wireless network adapters.

    REMEMBER 

    In effect, the WAP performs essentially the same function as a hub or switch performs for a wired network.

  • The WAP links your wireless network to your existing wired network so that your wired computer and your wireless computers get along like one big, happy family. (Sounds like the makings of a Dr. Seuss story. "Now the wireless sneeches had hubs without wires. But the twisted-pair sneeches had cables to thires….")

Tip 

Wireless access points are sometimes just called access points, or APs. An access point is a box that has an antenna (or, often, a pair of antennae) and an RJ-45 Ethernet port. You just plug the access point into a network cable and then plug the other end of the cable into a hub or switch, and your wireless network should be able to connect to your cabled network.

Figure 9-3 shows how an access point acts as a central connection point for wireless computers and how it bridges your wireless network to your wired network.

image from book
Figure 9-3: A wireless access point connects a wireless network to a cabled network.

Infrastructure mode

When you set up a wireless network with an access point, you're creating an infrastructure mode network. It's called infrastructure mode because the access point provides a permanent infrastructure for the network. The access points are installed at fixed physical locations, so the network has relatively stable boundaries. Whenever a mobile computer wanders into the range of one of the access points, it has come into the sphere of the network and can connect.

An access point and all the wireless computers that are connected to it are referred to as a Basic Service Set, or BSS. Each BSS is identified by a Service Set Identifier, or SSID. When you configure an access point, you specify the SSID that you want to use. The SSID is often a generic name such as wireless, or it can be a name that you create. Some access points use the MAC address of the WAP as the SSID.

Multifunction WAPs

Tip 

Wireless access points often include other built-in features. For example, some access points double as Ethernet hubs or switches. In that case, the access point will have more than one RJ-45 port. In addition, some access points include broadband cable or DSL firewall routers that enable you to connect to the Internet:

  • An 802.11b wireless access point that lets me connect a notebook computer and a computer located on the other side of the house because I didn't want to run cable through the attic.

  • A 4-port 10/100 MHz switch to which I can connect up to four computers by using twisted-pair cable.

  • A DSL/cable router that I connect to my cable modem. This enables all the computers on the network (cabled and wireless) to access the Internet.

Tip 

A multifunction access point that's designed to serve as an Internet gateway for home networks sometimes is a residential gateway.




Networking For Dummies
Networking For Dummies
ISBN: 0470534052
EAN: 2147483647
Year: 2004
Pages: 254
Authors: Doug Lowe

flylib.com © 2008-2017.
If you may any questions please contact us: flylib@qtcs.net