Kernel Boot


The next stage in the startup process involves loading the Linux kernel. The boot loader places the kernel in memory as well as initrd. As the kernel begins to execute, it unpacks initrd into a portion of memory specifically created at runtime to act as a physical disk drive. This new "disk" is then mounted as an initial root partition. This is done to facilitate the identification loading of modules the kernel will need to access the actual system / partition. Building all vendor and architecture disk device drivers right into the kernel would make it unacceptably large and inefficient. This preliminary look-ahead step using initrd allows for the dynamic loading of the appropriate module at boot time.

When the proper drivers are available to the kernel, the initrd RAM disk is unmounted, the memory reclaimed, and the proper / partition mounted. Before passing control over to the init routine, the kernel performs a series of steps to identify and load additional modules it will need.

To see the messages generated by the kernel when the system was started, you can use the dmesg command. This will list several hundred lines of device discovery and status information as the server starts up. The following is a synopsis of kernel messages generated during a typical boot sequence:

  • Checks the BIOS for a memory configuration

  • Turns on ACPI and other kernel parameters as described by the boot loader parameters

  • Starts CPU 0 and looks at its properties

  • Initializes the console to 80x25 characters

  • Checks the various busses for device and IRQ assignments

  • Scans for devices on the IRQs (serial ports, floppies, audio, and so on)

  • Detects disk drives and network cards

  • Loads appropriate modules for the system

  • Starts the init process

As the kernel loads, it dynamically loads the appropriate modules for the detected hardware. A careful review of the dmesg output will identify any serious errors that must be resolved.

After the kernel has finished loading all appropriate modules, it then passes control over to the init process. In the next section, we examine how this new startup process loads the remaining portions of the SLES install and makes it ready for use.



    SUSE LINUX Enterprise Server 9 Administrator's Handbook
    SUSE LINUX Enterprise Server 9 Administrators Handbook
    ISBN: 067232735X
    EAN: 2147483647
    Year: 2003
    Pages: 134

    flylib.com © 2008-2017.
    If you may any questions please contact us: flylib@qtcs.net